The Un-Official Proxomitron Forum / Proxomitron Filters / Filter Help/Request v / How to use $LST(Count) in Replace ?


Post Reply 
How to use $LST(Count) in Replace ?
Dec. 23, 2012, 10:03 PM
Post: #5
prxymouse Offline
Member
 		Posts: 17
Joined: Dec 2012
RE: How to use $LST(Count) in Replace ?
To quote Homer Simpson: Doh!

When I started looking into this $LST(Count) I also tried various patches and versions, somehow it seems I forgot to switch back to the "good" version and I was running 4.3.0 which of course doesn't support SET/GET at all. Going back to 4.5 did the trick and unique IDs are now created and I can finish my project.

Thank you very much and Happy Holidays!
Add Thank You Quote this message in a reply
Post Reply 


Messages In This Thread
RE: How to use $LST(Count) in Replace ? - JJoe - Dec. 22, 2012, 10:54 PM
RE: How to use $LST(Count) in Replace ? - JJoe - Dec. 23, 2012, 05:26 PM
RE: How to use $LST(Count) in Replace ? - prxymouse - Dec. 23, 2012 10:03 PM

Forum Jump:


Contact Us | The Un-Official Proxomitron Site | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication